Chongqing Manual Temperature Measuring Instrument Plastic Shells with Complete Variety, Foshan PFA Plastic Parts Manufacturer Supply

Dongguan Dinghao Plastic Technology Co., Ltd. will uphold the spirit of utmost sincerity and trustworthiness, continuous struggle, and pursuit of excellence. Centering on customer needs, we focus on developing products that comply with user and operator standards for production and environmental friendliness, providing comprehensive solutions, establishing trustworthy and mutually beneficial relationships with customers, and continuously pursuing and exploring green sustainable development models.

Product quality is the guarantee of a company's survival. Only with excellent quality can we create a good reputation and establish a strong brand image. Dongguan Dinghao Plastic Technology Co., Ltd. always prioritizes quality. Only by adhering to this belief can we stand at the forefront of the market.

Name: Handheld Temperature Measuring Device Shell

Model: MPT-00407

Length: 190±0.5mm

Width: 155±0.5mm

Diameter: 43±0.5mm

Material: ABS

Color: White

Weight: 115g

Note: The above data is for reference only,

Please refer to the actual product,

Customization available with provided drawings or samples

Common Four Major Problems and Solutions in Plastic Mold Forming
Problem One: Scorching Scorching is the premature vulcanization of plastic, where poor mold flow causes deformation or incomplete parts before the plastic flow in the mold is completed. To prevent or eliminate scorching, ensure the mold is completely filled before the plastic begins to vulcanize and that the mold cavity is evenly heated.
Problem Two: Backflow This is the deformation of the molded product at the mold parting line, often in the form of tearing or rugged indentations. Backflow is usually caused by the sudden release of internal pressure in the part when the mold opens. Therefore, to prevent it, avoid rough or excessive openings at the mold parting line and maintain the molding temperature as low as possible with the vulcanizing agent used.
Problem Three: Entrapped Air Air trapped in the plastic mold or plastic can cause soft, discolored areas on the surface or cross-section of the molded part due to incomplete vulcanization. Solutions include the following four points: 1. Collision mold. 2. Increase the amount of vulcanizing agent. 3. Use high-temperature vulcanizing agents with lower air reactivity. 4. Vent at sharp corners and undercuts of the mold.
Problem Four: Surface Discoloration This is usually due to excessive buildup of release agent in the plastic mold cavity or too much dust or dirt in the preform. To prevent such problems, clean the mold regularly, keep the preforms clean, and use release agents cautiously.